TOPIC
The following list provides an explanation of system errors 0 to -261.
DISCUSSION Note: Items listed in [brackets] are old result code meanings. Note: ???? This information wasn't available. General System Errors (VBL Mgr, Queue, Etc.) 0 noErr 0 for success *OR* 0 smNotTruncated No truncation necessary -1 qErr queue element not found during deletion *OR* -1 smTruncErr Truncation indicator alone is wider than the specified width -2 vTypErr invalid queue element -3 corErr core routine number out of range -4 unimpErr unimplemented core routine -5 SlpTypeErr invalid queue element -8 seNoDB no debugger installed to handle debugger command Color Manager Errors -9 iTabPurgErr from Color2Index/ITabMatch -10 noColMatch from Color2Index/ITabMatch -11 qAllocErr from MakeITable -12 tblAllocErr from MakeITable -13 overRun from MakeITable -14 noRoomErr from MakeITable -15 seOutOfRange from SetEntry -16 seProtErr from SetEntry -17 i2CRangeErr from SetEntry -18 gdBadDev from SetEntry -19 reRangeErr from SetEntry -20 seInvRequest from SetEntry -21 seNoMemErr from SetEntry I/O System Errors -17 controlErr Driver can't respond to Control call -18 statusErr Driver can't respond to Status call -19 readErr Driver can't respond to Read call -20 writErr Driver can't respond to Write call -21 badUnitErr Driver ref num doesn't match unit table -22 unitEmptyErr Driver ref num specifies NIL handle in unit table -23 openErr Requested read/write permission doesn't match driver's open permission, or Attempt to open RAM serial Driver failed -24 closErr Close failed; Permission to close .MPP driver was denied -25 dRemovErr tried to remove an open driver -26 dInstErr DrvrInstall couldn't find driver in resources -27 abortErr IO call aborted by KillIO; Publisher has written a new edition *OR* -27 iIOAbortErr IO abort error (Printing Manager) -28 notOpenErr Couldn't rd/wr/ctl/sts cause driver not opened -29 unitTblFullErr Unit table has no more entries -30 dceExtErr dce extension error File System Errors -33 dirFulErr Directory full -34 dskFulErr Disk full -35 nsvErr No such volume; volume not found -36 ioErr I/O error (bummers) -37 bdNamErr Bad file name; there may be no bad names in the final system! -38 fnOpnErr File not open -39 eofErr End of file; no additional data in the format -40 posErr Tried to position to before start of file (r/w) -41 mFulErr Memory full (open) or file won't fit (load) -42 tmfoErr too many files open -43 fnfErr File not found; Folder not found; Edition container not found; Target not found -44 wPrErr Diskette is write protected; Volume is locked through hardware -45 fLckdErr File is locked -45 fLckedErr Publisher writing to an edition -46 vLckdErr Volume is locked through software -47 fBsyErr File is busy (delete); Section doing I/O -48 dupFNErr Duplicate filename (rename); File found instead of folder -49 opWrErr File already open with with write permission -50 paramErr Error in user parameter list -51 rfNumErr Reference number invalid -52 gfpErr Get file position error -53 volOffLinErr Volume is off line -54 permErr Software lock on file; Not a subscriber [permissions error on file open] -55 volOnLinErr drive volume already on-line at MountVol -56 nsDrvErr no such drive (tried to mount a bad drive num) -57 noMacDskErr not a mac diskette (sig bytes are wrong) -58 extFSErr External file system - file system identifier is nonzero -59 fsRnErr file system internal error: during rename the old entry was deleted but could not be restored╔ -60 badMDBErr bad master directory block -61 wrPermErr Write permissions error; Not a publisher Font Manager Errors -64 fontDecError error during font declaration -65 fontNotDeclared font not declared -66 fontSubErr font substitution occured Disk, Serial Ports, Clock Specific Errors -64 lastDskErr -64 noDriveErr drive not installed -65 offLinErr r/w requested for an off-line drive -66 noNybErr couldn't find 5 nybbles in 200 tries -67 noAdrMkErr couldn't find valid addr mark -68 dataVerErr read verify compare failed -69 badCksmErr addr mark checksum didn't check -70 badBtSlpErr bad addr mark bit slip nibbles -71 noDtaMkErr couldn't find a data mark header -72 badDCksum bad data mark checksum -73 badDBtSlp bad data mark bit slip nibbles -74 wrUnderrun write underrun occurred -75 cantStepErr step handshake failed -76 tk0BadErr track 0 detect doesn't change -77 initIWMErr unable to initialize IWM -78 twoSideErr tried to read 2nd side on a 1-sided drive -79 spdAdjErr unable to correctly adjust disk speed -80 seekErr track number wrong on address mark -81 sectNFErr sector number never found on a track -82 fmt1Err can't find sector 0 after track format -83 fmt2Err can't get enough sync -84 verErr track failed to verify -84 firstDskErr -85 clkRdErr unable to read same clock value twice -86 clkWrErr time written did not verify -87 prWrErr parameter ram written didn't read-verify -88 prInitErr InitUtil found the parameter ram uninitialized -89 rcvrErr SCC receiver error (framing, parity, OR) -90 breakRecd Break received (SCC) AppleTalk Errors -91 ddpSktErr Error opening socket *OR* -91 eMultiErr Invalid address or table is full -92 ddpLenErr Data length too big *OR* -92 eLenErr Packet too large or first entry of the write-data structure did not contain the full 14-byte header -93 noBridgeErr No router available [for non-local send] -94 lapProtErr error in attaching/detaching protocol *OR* -94 LAPProtErr Protocol handler is already attached, node's protocol table is full, protocol not attached, or protocol handler pointer was not 0 -95 excessCollsns Hardware error [excessive collisions on write] -97 portInUse driver Open error code (port is in use) -98 portNotCf driver Open error code (parameter RAM not configured for this connection) -99 memROZErr hard error in ROZ -99 memROZError hard error in ROZ -99 memROZWarn soft error in ROZ Scrap Manager Errors -100 noScrapErr No scrap exists error -102 noTypeErr Format not available [no object of that type in scrap] Storage Allocator Errors -108 memFullErr Ran out of memory [not enough room in heap zone] -109 nilHandleErr GetHandleSize fails on baseText or substitutionText; NIL master pointer [handle was NIL in HandleZone or other] -110 memAdrErr Address was odd, or out of range -111 memWZErr Attempted to operate on a free block; GetHandleSize fails on baseText or substitutionText [WhichZone failed (applied to free block)] -112 memPurErr Trying to purge a locked or non-purgeable block -113 memAZErr Address in zone check failed -114 memPCErr Pointer Check failed -115 memBCErr Block Check failed -116 memSCErr Size Check failed -117 memLockedErr Trying to move a locked block (MoveHHi) HFS Errors -120 dirNFErr Directory not found -121 tmwdoErr No free WDCB available -122 badMovErr Move into offspring error -123 wrgVolTypErr Not an HFS volume [wrong volume type error or (obsolete) operation not supported for MFS] -124 volGoneErr Server volume has been disconnected. -125 updPixMemErr Insufficient memory to update a pixmap -127 fsDSIntErr Internal file system error Menu Manager Errors -126 dsMBarNFnd System error code for MBDF not found -127 dsHMenuFindErr Could not find HMenu's parent in MenuKey -128 userCanceledErr User canceled an operation HFS FileID Errors -130 fidNotFound no file thread exists -131 fidNotAFile directory specified -132 fidExists file id already exists Color Quickdraw & Color Manager Errors -147 regionTooBigError Region too big or complex -148 pixMapTooBigErr Pixel map record is deeper than 1 bit per pixel [passed pixelmap is too large] -149 notEnoughStack Not enough stack space for the necessary buffers *OR* -149 mfStackErr Insufficient stack -150 cMatchErr Color2Index failed to find an index -151 cTempMemErr Failed to allocate memory for temporary structures -152 cNoMemErr Failed to allocate memory for structure -153 cRangeErr Range error on colorTable request -154 cProtectErr ColorTable entry protection violation -155 cDevErr Invalid type of graphics device -156 cResErr Invalid resolution for MakeITable -157 cDepthErr Invalid pixel depth -158 cParmErr Invalid parameter Resource Manager Errors (other than I/O) -185 badExtResource Extended resource has a bad format. -186 CantDecompress Resource bent ("the bends") can't decompress a compressed resource -188 resourceInMemory Resource already in memory -189 writingPastEnd Writing past end of file -190 inputOutOfBounds Offset or count out of bounds -192 resNotFound Resource not found -193 resFNotFound Resource file not found -194 addResFailed AddResource failed -195 addRefFailed AddReference failed -196 rmvResFailed RmveResource failed -197 rmvRefFailed RmveReference failed -198 resAttrErr Attribute inconsistent with operation -199 mapReadErr Map inconsistent with operation Sound Manager Errors -200 noHardware Required sound hardware not available [no hardware support for the specified synthesizer] -201 notEnoughHardware Insufficient hardware available [no more channels for the specified synthesizer] -203 queueFull No room in the queue -204 resProblem Problem loading the resource -205 badChannel Channel is corrupt or unusable [invalid channel queue length] -206 badFormat Resource is corrupt or unusable [handle to 'snd ' resource was invalid] -207 notEnoughBufferSpace Insufficient memory available -208 badFileFormat File is corrupt or unusable, or not AIFF or AIFF-C -209 channel Channel is busy -210 buffersTooSmall Buffer is too small -211 channelNotBusy Channel not currently used -212 noMoreRealTime Not enough CPU time available -213 badParam A parameter is incorrect -220 siNoSoundInHardware No sound input hardware available -221 siBadSoundInDevice Invalid sound input device -222 siNoBufferSpecified No buffer specified -223 siInvalidCompression Invalid compression type -224 siHardDiskTooSlow Hard drive too slow to record -225 siInvalidSampleRate Invalid sample rate -226 siInvalidSampleSize Invalid sample size -227 siDeviceBusyErr Sound input device is busy -228 siBadDeviceName Invalid device name -229 siBadRefNum Invalid reference number -230 siInputDeviceErr Input device hardware failure -231 siUnknownInfoType Unknown type of information -232 siUnknownQuality Unknown quality MIDI Manager Errors -250 midiNoClientErr no client with that ID found -251 midiNoPortErr no port with that ID found -252 midiTooManyPortsErr too many ports already installed in the system -253 midiTooManyConsErr too many connections made -254 midiVConnectErr pending virtual connection created -255 midiVConnectMade pending virtual connection resolved -256 midiVConnectRmvd pending virtual connection removed -257 midiNoConErr no connection exists between specified ports -258 midiWriteErr couldn't write to all connected ports -259 midiNameLenErr name supplied is longer than 31 characters -260 midiDupIDErr duplicate client ID -261 midiInvalidCmdErr command not supported for port type |
||||||
| Document Information | |
| Product Area: | Mac OS System Software |
| Category: | General OS |
| Sub Category: | General Topics |
Copyright © 2000 Apple Computer, Inc. All rights reserved.